Enertex® DUAL KNX PowerSupply 1280 - Firmware - Changelog
-----------------------------------------------------------------------------
1.013 (2022-07-11):
    Fixed:
     - If output objects of a device are linked with a input object of the same device, then the value of the object is not updated at the input object.
     - In KNX-Data-Secure-Mode group objects with an ID higher than 77 were ignored
1.012 (2021-07-09):
    Fixed:
     - Real time clock ran to fast. So internal time of power supply gets a diviation of about 4s per day from real time.
1.011 (2021-04-12):
    Fixed:
     - Bug of version 1.010 fixed: The values in the predefined telegrams for the time switches were sent incorrectly.

1.010 (2021-03-03):
    * New: 
        - A bus current smaller than 22mA is now shown at the display with "<22 mA". Older versions showed 0 mA, if the current was below 22 mA (lowest possible current detection threshhold).
    Fixed:
     - Order of the bytes in the DPT Datatype RGB is corrected. Objects with this type are only used in the time switches.
     
1.007 (2021-01-11):
    * New: 
        - Switch Times, which are set via group addresses, are now saved and restored, when the device is restarted by a power reset, a bus reset or a reset via ETS.
        - The values in the object "status text message" (CO14) are now left aligned, if there is no text parametrized in front of the values.
          So the text can be better displayed on Enertex® Meta and Enertex® Synohr room controller.
        - Telegram rates (CO62 and CO63) are now sent, if a request via "Request Measurement values" (CO48) is triggered.
    Fixed:
     - The month at the date shown on the display at the extreme values is now displayed correctly.
     - The voltage at Aux output is now sent via the object "status text message" (CO14), if parametrized.
        
1.006 (2020-11-11):
    * New: 
        - New option at the conditions of the time switch: "Period 1 - 5" and "Period 6 - 10"

1.005 (2020-11-06):
        - Inital released version